Twin Satellite Shotgun Coax Cable for Sky Q, Sky HD, Sky+ and Freesat - Black

£9.9
FREE Shipping

Twin Satellite Shotgun Coax Cable for Sky Q, Sky HD, Sky+ and Freesat - Black

Twin Satellite Shotgun Coax Cable for Sky Q, Sky HD, Sky+ and Freesat - Black

RRP: £99
Price: £9.9
£9.9 FREE Shipping

In stock

We accept the following payment methods

Description

The next coaxial cable size is 1.25mm cable. This almost always used in communal TV systems to overcome signal losses on long cable runs. 125 cable will typically lose around 2.5dB per 10m at the highest frequency so you can for it to be a worthwhile upgrade over 1mm coax you would need a long cable length. When you get to this cable size normal screw on type plugs start to become unsuitable and you should consider using compression and crimp on style plugs instead. Also when you get to this cable size and above it isn’t suitable for terminating into wall plates, LNB’s, aerials etc. Use a double-ended 'joiner barrel' outside and a suitable f-plug on the new aerial cable - then well-wrapped in self-amalgamating tape. http://www.satcure.co.uk/tech/extend_cable.htm Every piece of TV aerial/ satellite equipment will have a maximum signal strength that it can handle and the signal level in your system should never be allowed to go beyond this as this could overload your equipment and cause poor TV reception, including loss of signal and pixelation. It could even damage the parts/ components of the equipment. If you need to amplify the signals to very high levels like is the case for communal TV systems, you will need a professional launch amplifier to do this which can carry a high signal strength through it. Please note that this has been written from a TV aerial/satellite perspective, so we are focusing on the best coax cables for Sky, Freeview & Freesat. There are lot of other types that are used in CCTV and data cabling functions which are not mentioned in this blog. If you read the early part of this blog you will see I talked about the different coaxial cable sizes, this depends on the cables lengths that you’re installing. I again rate Webro the highest so if you’reinstalling a communal IRS system, I recommend WF100, WF125 and WF165 as suitable cables for doing so. You may even want to get these a multi-core cable to assist with the installation.

If the signal loss is too great, consider repeating this process for a larger conductor coax cable. The kits we provide are available in an array of lengths including: 3m, 5m, and 10m. There is no requirement to make the extension cables yourself, as they are supplied complete and “ready-made”. Therefore there is no need for messing around with pliers and cutters. The cable consists of 1 cable with 2 feeds, so it is not a requirement to run 2 separate wires, you simply plug and play.If you’re planning you own TV aerial or satellite dish installation and require a particularly long length of coax cabling between your antenna and your TV, or if you want to connect your outbuilding/ shed etc., which may be some distance away with a reliable TV signal, read this article for all you need to know. In this blog I discuss maximum lengths of coax cables, signal losses and how to overcome these with things such as amplification. Without any further ado, let’s begin. Finally, we get to the part of the blog where I actually recommend cable types for TV systems. I’m just going to bunch a whole bunch of cables here as they’re essentially the same cable made by different manufacturers. Traditional coaxial cable that people are most familiar with is 1mm centre conductor coaxial cable, but another common cable size used especially for Sky installations that often connect with a “shotgun” cable has a 0.65mm centre conductor and you need to make sure that you have the correct sized plug for this cable type which is slimmer. Like normal coaxial cable sizes F plugs for this cable size can be obtained in screw on, crimp on and compression types. The 0.65mm screw on plugs usually but not always also have a few rings on the body so these can be easily found when in a mixture of coax plugs. When you have an upgrade to Sky Q the Sky installer or indepdent satellite engineer will change your own quad LNB to a wideband LNB. Instead of doing this a dSCR LNB could be installed instead. There are a few models available but some have separate legacy outputs that will allow you to connect extra standard Sky or Freesat boxes. When you have the Sky Q box connected to the dSCR output on the LNB with a single cable. You need to set the Q box to single feed mode as described at the bottom of the blog. It can be run at different lengths including at lengths of over 200+ metres, without any loss of performance or quality.

There are many types for F plugs for different size coaxial cables and plugs that terminate differently like screw on F plugs, crimp on and compression plugs but in essence they are very similar. The massive 2 TB storage capacity enables you to watch one channel, whilst recording another. Additionally with multi-screen you don’t have to worry about drilling extra holes because with Wi-Fi you can stream HD video from your main box. To upgrade the whole communal system so that Sky Q can be operated on single feed mode, the existing multi-switch amplifiers will need to be upgraded for dSCR amplifiers. These allow either legacy Sky or Sky Q to be connected on the outputs and the switch between the two is done on the Sky Q receiver by selecting single feed mode within the settings. When the multi-switch amplifier detects the dSCR signal request it will switch to that,this is usually indicated on the multi-switch itself by a blinking LED on the output that is connected to your Sky Q box. If the LNB is a Sky Q only type then that won't work with other kit, such as a Freesat box or a TV with built in satellite tuner. You would need a Hybrid type that works with both or a "legacy" LNB that works with Freesat/TVs but not Sky Q.We also include wall mounting clips to facilitate connecting the Sky cable to a wall. Why Choose Our Sky Extension Cables? That being said the Sky+ would still work fine with one cable and the Sky box set to single feed mode, you just wouldn’t be able to record one programme and watch another. This isn’t the case with the Sky Q box as it needs two satellite cables connected to a wideband LNB. This is because the two signals are not identical like with Sky+ and Freesat+. With Sky Q one cable provides the vertical polarised signals and the other provides the horizontal signals, with one cable you will only get half of the services. But like I already said it is possible to Sky Q on one cable with no loss of services using dSCR technology. From time to time you will need to or it will be advantageous to adapt a F connection to a IEC connection or vice versa. In which case you will need an adapter plug. There so many types of adapter plugs out there that adapt one connection to another. The most common types I use are:



  • Fruugo ID: 258392218-563234582
  • EAN: 764486781913
  • Sold by: Fruugo

Delivery & Returns

Fruugo

Address: UK
All products: Visit Fruugo Shop